High Speed Domestic Floor Cleaning Machine For Marble Vinyl Wood Or Carpet

High Speed Domestic Floor Cleaning Machine For Marble Vinyl Wood Or Carpet

Product Description

1.This machine is suitable for indoor cleaning. Please read the instruction before use.
2.This machine is suitable for cleaning flat hard floor, wooden floor, tile floor, etc. It is not suitable for uneven floor and blanket.
3.suitable for cleaning dust on the ground and small areas of water stains, sauces, not suitable for cleaning large particles.
4.Cannot use 100 clean cloth to undertake cleanness to wooden floor, lest blow floor of beautiful wood.
5. Please be careful not to let children use it.
6. When the continuous discharge lasts for a long time until the complete discharge, rest for 30 minutes before charging to protect the battery and extend the service life.
7. Do not hold down the water spray switch for a long time when the water tank is dry under the starting state to avoid damaging the water pump.
8.The machine is not allowed to start up without installing brush cloth.
9. Do not touch the site or people with your hands during the use of the product.

10. when the product is in high gear, the noise will increase correspondingly when the resistance is high. It is recommended to use low gear cleaning.
11. After each completion of the machine, remove the wet cloth and keep it clean and dry to prevent mildew and rot.
12. Store the clean unit and all accessories in a dry and cool place.

Spec:

1. 3.6V lithium battery
2. Water tank capacity 120 ml
3. 25 mins working time
4. 3h charging time
5. Water spray bottle x1
6. Clean pad x1

Product Uses

Press both sides of screw box inwards and pull it out; take out screw by impact. Align the mounting hole of control handle with the mounting hole of chassis, install the screw and tighten the nut; Put screw box into on chassis.

Keep pad holder or brush flat on the floor, take hold of chassis and lift machine with both hands, align brush holder pad with pad holder or brush, push chassis hard, make pad holder or brush level and place it properly.

Lay the machine on its back with the handle lying on the floor; Turn over chassis backward and shown pad holder or brush, remove pad holder or brush on the brush holder pad.

Rotate the handle to the highest point, insert the pin in the special-purpose hole of motion, hold tight handle and makes the two wheels drop to the ground, than can push or pull the machine to move.